💚 SPRING SPECIAL | 20% OFF | 24.11–30.11 🌱

Eurorack Scope OLED Display

This is a Kit version of the HAGIWO Display Eurorack module.

The module is a OLED display running on an Arduino nano. It has 4 modes.
The microcontroller can be easily reprogrammed using the IDE and a USB cable.

We also offer a firmware uploader. With a few clicks, you can easily flash the module via web browser.

Pre-soldered SMD components: Perfect DIY project for beginners.
– Panel design by bkrsmdesign
– 128 * 64 pixel 0.96″ inch OLED display
– Rotary encoder with PRESSURE BUTTON
– Gain attenuation
– CHANGE/DC toggle switch
– TRIG INPUT
– INPUT (normalized)
– OUTPUT
– Voltage 5Vp-p
– Eurorack power cable included

– LFO / EG mode
– 1 recording mode
– Spectrum analyzer mode

 

| SMD Kit |
You will receive the pre-soldered SMD board and the front panel. You then have to take care of the appropriate microcontroller and the other components (encoder, OLED, jacks, etc.) yourself.
If you check the parts list, which you can find on the module page, and find that you already have all the components, then this is an option for you.

| Full Kit |
You will receive ALL components, as well as microcontroller, SMD PCB, display and the front panel. The firmware is pre-flashed.

| Built Unit |
You will receive a ready built unit. You do not have to assemble it yourself. The firmware is pre-flashed.

 

The assembly of the module is easy and suitable for beginners as only a few common parts are needed.

 

Please note: The Panel + PCB Kit does NOT come with an OLED included.

This is only listed because how our shop system is working.

 

45,00 99,00 

Join Waitlist We will inform you when the product arrives in stock. Please leave your valid email address below.
Join Waitlist We will inform you when the product arrives in stock. Please leave your valid email address below.