Visualize your modular patches with SCOPE – a compact, beginner-friendly OLED Display and oscilloscope for Eurorack. With full ±10V input range and buffered output.

SCOPE brings visual feedback to your modular in just 6HP. Watch your waveforms on the OLED display, analyze frequency content, and get a better understandin of your patches.

Perfect DIY Project:

SCOPE was designed with beginners in mind. All SMD components come pre-soldered, leaving only through-hole parts for you to assemble.

Available options:

| PCB & Front panel |

You get the pre-soldered SMDPCB and the front panel. You would then have to take care of the appropriate microcontroller and the other components (potentiometer, OLED, jacks, etc.) by yourself.

If you check the BOM that you can find on the module page and realize that you already have all the components with you, then this is an option for you.

| Complete Kit |

You get ALL components, as well as microcontroller, SMD PCB, display and the front panel.

| Built Unit |

You get a ready built unit. You do not have to assemble it yourself. The firmware is pre-flashed.

Features:

Full 20Vpp input range – complete Eurorack voltage range

Buffered output – clean signal pass-through for chaining modules

Web-based firmware uploader – update your SCOPE with just a few clicks.

Rotary Encoder with Push button for mode selection and parameter settings

TRIG IN (trigger for 1 Shot Mode)

INPUT (protected against over voltage)

Tuner mode

DIY Info:

The assembly of the module is easy and suitable for beginners as only a few common parts are needed.

Please note: The “PCB + Panel” does NOT come with an OLED included.

More information and assembly instructions, firmware, parts list can be found here:

SCoPE OLED Display

Modulargrid: https://www.modulargrid.net/e/modulove-hagiwo-oled-display-oscilloskop-spectrum-analyzer

Github: https://github.com/modulove/SCOPE/